How To Set Up Zephyr X-Stands

CMYK Bar

ZEPHYR X-STAND SET-UP GUIDE (1-SIDED)

01 - Contents: One [1] telescopic pole with two [2] rods, one [1] bottom crossbeam with wire attached to plastic piece, and one [1] stand base.

02 - If the plastic piece attached by wire to the crossbeam is not already attached to the base, turn the base over, then slide the rounded end of the plastic piece into the slot on the underside of base.

03 - Turn base right side up, remove the blue cap. Fill the base with ballast (sand, water, or something similar) and then replace the blue cap.

04 - Insert the telescoping pole into the open hole located near top-rear of base.

05 - Extend the lower cross beam and adjust length as needed to match the width of your banner.

06 - Attach the banner to the two [2] hooks at the top of the stand first.

07 - Attach the bottom of banner to the two hooks on the crossbeam previously connected to the base.

08 - Twist knob on the pole counter-clockwise to unlock the telescoping pole and adjust the pole upwards until the banner becomes taut. Secure the banner by turning the knob clockwise until it locks into position.

09 - YOUR SINGLE-SIDED ZEPHYR-X BANNER STAND IS READY TO USE!

CMYK Bar

ZEPHYR X-STAND SET-UP GUIDE (2-SIDED)

01 - Contents: One [1] large pole, one [1] small pole with rod holders, two [2] rods with double hooks, and four [4] rods with single hooks.

02 - Remove the blue cap. Fill the base with ballast (sand, water, or something similar) and then replace the blue cap.

03 - Insert the small pole with rod holders into the end of the large pole with the recessed plastic end piece.

04 - Insert the previously-assembled pole into the open hole located near the rear of the base.

05 - Insert one of the double hook rods into the circular plastic rod holder (with only two holes) at the top of pole.

06 - Insert the remaining four rods into the other rod holder (the one with four holes).

07 - Attach the first banner to the top of the stand. Repeat by attaching the second banner in the same way.

08 - Attach the bottom of both banners to the rods at the bottom of the stand.

09 - Once both banners are attached, press the button on the shaft of small pole to release the mechanism, and then slide the mechanism downwards until the banner becomes taut and you hear the mechanism lock into place.

10 - YOUR DOUBLE-SIDED ZEPHYR-X BANNER STAND IS READY TO USE!

CMYK Bar

ORDER YOUR X-STANDS NOW

Zephyr X-Stands
Zephyr X-Stands
  • $204.99 Printed
  • $164.99 Banner Stand Only

More X-Stands
More X-Stands
Customer Service personnel are available during our service & support hours (all times Eastern):
  • 9:00 AM to 11:00 PM, Monday – Thursday
  • 9:00 AM to 10:00 PM, Friday
  • 10:00 AM to 4:00 PM, Saturday
  • You're welcome to contact us by Telephone (1-800-494-5850), Email (cs@esigns.com), Live Chat (using the button located in the top-right on eSigns.com), or Support Ticket.