ZEPHYR X-STAND SET-UP GUIDE
(SIZE: 60"×24" — 1-SIDED)
01 - Contents: One  telescopic pole with two  rods, one  bottom crossbeam with wire attached to plastic piece, and one  stand base.
02 - If the plastic piece attached by wire to the crossbeam is not already attached to the base, turn the base over, then slide the rounded end of the plastic piece into the slot on the underside of base.
03 - Turn base right side up, remove the blue cap. Fill the base with ballast (sand, water, or something similar) and then replace the blue cap.
04 - Insert the telescoping pole into the open hole located near top-rear of base.
05 - Extend the lower cross beam and adjust length as needed to match the width of your banner.
06 - Attach the banner to the two  hooks at the top of the stand first.
07 - Attach the bottom of banner to the two hooks on the crossbeam previously connected to the base.
08 - Twist knob on the pole counter-clockwise to unlock the telescoping pole and adjust the pole upwards until the banner becomes taut. Secure the banner by turning the knob clockwise until it locks into position.
09 - YOUR SINGLE-SIDED ZEPHYR-X BANNER STAND IS READY TO USE!
Customer Service personnel are available during our service & support hours (all times Eastern):
- 9:00 AM to 11:00 PM, Monday – Thursday
- 9:00 AM to 10:00 PM, Friday
- 10:00 AM to 4:00 PM, Saturday
You're welcome to contact us by Telephone (1-800-494-5850), Email (firstname.lastname@example.org), Live Chat (using the button located in the top-right on eSigns.com), or Support Ticket.