Jumbo Backdrop Stand (Light Duty)

JUMBO BACKDROP STAND (LIGHT DUTY)
SET-UP AND BANNER INSTALLATION GUIDE

01 - Contents: One [1] Philips head screwdriver and two [2] screws, two [2] metal feet, two [2] telescoping poles with rounded ends, two [2] telescoping poles with flat ends, and four [4] bolts with knobs.

Light Duty Jumbo (Step 1)

02 - Insert one of the flat-ended poles into the circular hole in a metal foot and use a Philips head screw to secure the pole to the metal foot with the screwdriver.  Repeat this for the second flat-ended pole and metal foot.

Light Duty Jumbo (Step 2)

03 - Adjust height of each pole attached to the feet as needed.

Light Duty Jumbo (Step 3)

04 - Lay banner out flat, take one of the round-ended poles and adjust its length so that it is longer than the banner's width and extends out from both sides of the banner's pole pocket.

Light Duty Jumbo (Step 4)

05 - Insert adjusted pole through the banner's bottom pole pocket. Attach this pole to the two vertical poles previously attached to the metal feet with two bolts near the base.
Light Duty Jumbo (Step 5)

06 - Repeat size adjustment Steps 4 and 5 with the top horizontal bar before inserting it through the banner's top pole pocket. Attach this pole using the top holes on the vertical poles with the two remaining bolts.

Light Duty Jumbo (Step 6)

07 - YOUR LIGHT DUTY JUMBO BACKDROP BANNER STAND IS READY TO USE!

Light Duty Jumbo (Step 7) - Done!

Add Feedback