L-Stand Instructions (90"×36")

L-STAND SET-UP AND BANNER
INSTALLATION GUIDE (90"×36")

01 - Contents: Two [2] long pole with metal connectors, two [2] long poles without metal connectors, two [2] medium poles, two [2] short poles (do not use these short poles), and two [2] L-Stand bases.

02 - Unroll banner and lay it out flat, face down.

03 - Move the angled pole holders at the piece that will be the top of the stand to the outer edges of the banner.

04 - Slide the end caps off of each side of the pole that will be the bottom of the stand and attach both base pieces to that that pole.  Once attached, replace the end caps.

05 - Assemble Upright Poles: Attach one [1] large pole with metal connector, one [1] large pole without metal connector, and one [1] medium pole to each other.  Repeat this for the second upright pole.

06 - Insert the MEDIUM end of a pole you've just assembled into the angled pole holder at top of stand.  Repeat this with the second pole.

07 - Attach bottoms of both poles to each of the base pieces previously attached to the bottom pole of banner stand in Step 4.

08 - YOUR 90"×30" L-STAND IS READY TO USE!

Add Feedback